LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Power Steering System) >> Repair Instructions >> Power Steering Gear Outlet Pipe/Hose Replacement (Rack and Pinion) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the power steering outlet hose (4) to the power steering cooler (5).
  2. Connect the power steering outlet hose (4) to the power steering gear (3). Hand tighten only.
    Fig 1: Power Steering Gear Outlet Pipe/Hose (Rack and Pinion)
    GM363050Courtesy of GENERAL MOTORS CORP.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Connect the power steering outlet hose (2) to the power steering pump (1).

    Tighten:  Tighten both hose connections to 28 N.m (20 lb ft).

  4. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  5. Inspect all the hose connections for leaks.
scientia non olet · About LEMON Manuals