LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (Without Hydroboost) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
    3. NOTE: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
  3. Install a drain pan under the vehicle.
  4. Remove the power steering gear inlet hose (3) from the power steering pump (1).
    Fig 1: Removing The Power Steering Gear Inlet Hose From The Power Steering Pump (Without Hydroboost)
    GM748675Courtesy of GENERAL MOTORS CORP.
  5. Remove the power steering gear inlet hose from the power steering gear.
  6. Remove the power steering gear inlet hose from the vehicle.
scientia non olet · About LEMON Manuals