LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (Rack and Pinion) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
  1. Remove the power steering inlet hose (2) from the power steering pump (1).
    Fig 1: Power Steering Gear Inlet Pipe/Hose (Rack and Pinion)
    GM363050Courtesy of GENERAL MOTORS CORP.
  2. Remove the power steering inlet hose (2) from the power steering gear (3).
scientia non olet · About LEMON Manuals