LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (Rack and Pinion) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the power steering inlet hose (2) to the power steering gear (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Power Steering Gear Inlet Pipe/Hose (Rack and Pinion)
    GM363050Courtesy of GENERAL MOTORS CORP.
  2. Connect the power steering inlet hose (2) to the power steering pump (1).

    Tighten:  Tighten the hose connections to 28 N.m (20 lb ft.)

  3. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  4. Inspect all the hose connections for leaks.
scientia non olet · About LEMON Manuals