LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (With Hydroboost) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front grille. Refer to Grille Replacement (GMC) or Grille Replacement (Chevrolet) in Exterior Trim.
    2. NOTE: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
  2. Place a drain pan under the vehicle.
  3. Siphon the fluid from the reservoir to prevent excess spillage.
  4. Remove the clamp retaining the power steering cooler inlet hose (3) to the power steering gear (2).
  5. Remove the clamp retaining power steering cooler outlet hose (5) to the power steering pump (1).
    Fig 1: Removing Power Steering Cooler Hoses From Steering Gear (With Hydroboost)
    GM686126Courtesy of GENERAL MOTORS CORP.
    6. Fig 2: Removing Power Steering Cooler From The Vehicle (With Hydroboost)
    GM686121Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts (2) retaining the power steering cooler from the radiator support.
  7. Remove the power steering cooler from the vehicle.
scientia non olet · About LEMON Manuals