LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (Rack and Pinion) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front grille. Refer to Grille Replacement (GMC) or Grille Replacement (Chevrolet) in Exterior Trim.
    2. NOTE: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
    Fig 1: Removing Power Steering Cooler Hoses From Steering Gear (Rack and Pinion)
    GM363050Courtesy of GENERAL MOTORS CORP.
  2. Remove the power steering outlet hose (4) from the power steering gear (3).
  3. Remove the power steering inlet hose from the power steering pump (1).
    4. Fig 2: Removing Power Steering Cooler From The Vehicle (Rack and Pinion)
    GM686121Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts (2) retaining the cooler to the radiator support.
  5. Remove the power steering cooler from the vehicle.
scientia non olet · About LEMON Manuals