LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Shift Interlock Systems) >> Removal & Installation >> Floor Console >> Installation

Floor Console: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the center console to the vehicle. Adjust the parking brake to the or fully engaged position. See Fig 1 . Connect the electrical connectors as necessary.
  2. Lower the rear of the console and slide the console forward into position. Ensure the 2 retaining ears on the front extensions of the console are fully engaged to the lower instrument panel (Bravada only).
  3. Install the center console retaining screws. Tighten the screws to 22 INCH lbs. (2.5 N.m). Install the console storage bin. See FLOOR CONSOLE STORAGE BIN  .
  4. Install the center console shift lever bezel. Install the floor shift knob. See FLOOR SHIFT KNOB  .
  5. Install the rubber ash tray inserts and rubber mat to the console. Remove the bocks from the vehicle.
Fig 1: Removing & Installing Floor Console Assembly
G00102980Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals