LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 984 (Garage Door Opener System) >> Repair Instructions >> Garage Door Opener Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the garage door opener to the overhead console.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the garage door opener retaining screws.

    Tighten:  Tighten the retaining screws to 2 N.m (18 lb in).

  4. Connect the electrical connector to the garage door opener.
  5. Fig 1: Garage Door Opener Retaining Screw
    GM688856Courtesy of GENERAL MOTORS CORP.
  6. Install the console to the roof.
  7. Connect the electrical connectors.
  8. Install the overhead console retaining screw.

    Tighten:  Tighten the overhead console retaining screw to 2 N.m (18 lb in).