LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Trim Panel Replacement - Front Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the trim panel on the seat from the front to the back.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Instal the trim panel (1) to the seat by pushing in until the retaining clips are locked in place.
    3. Fig 1: Front Seat Trim Panel
    GM833483Courtesy of GENERAL MOTORS CORP.
  3. Install the screws retaining the seat back release handle and the seat recliner handle to the seat, if removed.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals