LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Seat Replacement - Rear (Extended Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the seat back clips on the retaining hooks.
  2. Install the rear storage compartment bracket, If removed. Refer to Tool Storage Compartment Bracket Replacement (PRO) in Interior Trim.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the seat retaining bolts (1).

    Tighten:  Tighten the seat retaining bolts to 55 N.m (41 lb ft).

    4. Fig 1: Installing Rear Seat & Bolts (Extended Cab)
    GM363716Courtesy of GENERAL MOTORS CORP.
  4. Fold the seat down.
  5. Pull the seat belt buckles through the seat cushion and seat back.
scientia non olet · About LEMON Manuals