LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Seat Replacement - Rear (60/40 Split) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat into the vehicle.
    2. Fig 1: Installing Rear Seat (60/40 Split)
    GM276317Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the seat retaining bolts.

    Tighten:  Tighten the bolts to 55 N.m (41 lb ft).

  3. Connect the electrical connectors, if equipped.
  4. Install the jack assembly, if removed.
  5. Install the covers to the seat bolts.
  6. Install the seat back recliner handle screw, if removed.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  7. Install the front and the rear leg trim covers.
scientia non olet · About LEMON Manuals