LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Seat Replacement - Front Bucket >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat in the vehicle.
  2. Connect the electrical harness, if equipped.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Move the seat to the full forward position in order to install the seat retaining rear bolts (1).

    Tighten:  Tighten the retaining rear bolts to 55 N.m (41 lb ft).

  4. Move the seat to the full rearward position and install the seat retaining front nuts (2).

    Tighten:  Tighten the nuts to 55 N.m (41 lb ft).

  5. Install the front seat adjuster nut cover (3), if equipped.
    6. Fig 1: Installing Front Bucket Seats
    GM363709Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals