LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Seat Back Recliner Handle Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the recliner handle on the side shield.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screw retaining the recliner handle to the trim panel.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    3. Fig 1: Installing Front Seat Back Recliner Handle & Bolt
    GM378527Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals