LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Seat Back Hinge/Recliner Mechanism Replace - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat from the vehicle. Refer to Seat Replacement - Front Bucket .
  2. Remove the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  3. Remove the seat cushion frame. Refer to Seat Cushion Frame Replacement - Front .
  4. Remove the seat back frame. Refer to Seat Back Frame Replacement - Front .
  5. Remove the outboard pivot bolt.
    6. Fig 1: Removing Outboard Pivot Bolt
    GM381498Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts holding the seat back folding mechanism.
    7. Fig 2: Removing Front Seat Back Folding Mechanism Bolts
    GM378534Courtesy of GENERAL MOTORS CORP.
  7. Unsnap the recliner cable (1) from the folding mechanism (3).
  8. Remove the front recliner attachment bolts (4).
  9. Remove the recliner screw (5).
    10. Fig 3: Removing Recliner Components
    GM396820Courtesy of GENERAL MOTORS CORP.
  10. Remove the U-channel (1).
    11. Fig 4: Removing U-Channel
    GM381469Courtesy of GENERAL MOTORS CORP.
  11. Remove the drive cable, if equipped with a power recliner.
  12. Disconnect the recliner cable from the recliner mechanism.
  13. Remove the recliner from the seat frame.
scientia non olet · About LEMON Manuals