LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the head restraint. Refer to Head Restraint Replacement .
  2. Remove the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  3. Remove the nut from the lower seat belt anchor.
    4. Fig 1: Removing Lower Seat Belt Anchor Nut
    GM381493Courtesy of GENERAL MOTORS CORP.
  4. Disengage the J-strip retainer on the bottom of the seat back cover.
  5. Disconnect the heater seat element connector, if equipped.
  6. Using a side motion, carefully lift the seat back cover partially off the foam pad in order to access the arm rest clip.
    7. Fig 2: Removing Seat Back Cover
    GM381479Courtesy of GENERAL MOTORS CORP.
  7. Remove the armrest, if equipped. Refer to Armrest Replacement - Front Seat .
  8. Using a flat-bladed tool, lift the seat cover over the air bag cover.
  9. Remove the seat cover to the top of the seat.
  10. Disengage the panel fasteners in order to remove the rear cardboard panel.
  11. Unclip the head restraint retainers. Refer to Head Restraint Retainer Replacement - Front Seat .
  12. Remove the bolts which retain the seat belt tower cover.
    13. Fig 3: View Of Seat Belt Tower Cover/Panel Bolt
    GM378543Courtesy of GENERAL MOTORS CORP.
  13. Remove the seat belt tower cover.
    14. Fig 4: Locating Retractor Tower Retaining Screw
    GM381472Courtesy of GENERAL MOTORS CORP.
  14. Pull the seat belt and the seat belt bezel through the opening in the seat cover.
  15. Lift the remainder of the seat back cover off the foam pad.
  16. Carefully remove the foam pad from the frame.
scientia non olet · About LEMON Manuals