LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Front (Manual) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cushion tilt mechanism, if equipped.
  2. Install the EZ entry rod (4), if equipped with the EZ entry feature.
  3. Install the cross brace (3).
  4. Install the bar (1) onto the racks (2). Bend the tabs in order to secure the bar.
    5. Fig 1: Seat Adjuster Bar, Tracks, Cross Brace & EZ Rod
    GM396777Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the inboard seat belt buckle and nut (1).

    Tighten:  Tighten the nut to 53 N.m (39 lb ft).

  6. Connect the electrical connection (2).
    7. Fig 2: View Of Seat Belt Buckle, Nut & Electrical Connection
    GM381486Courtesy of GENERAL MOTORS CORP.
  7. Install the seat adjuster track cover. Refer to Seat Adjuster Track Cover Replacement - Front .
  8. Install the seat back hinge/recliner mechanism. Refer to Seat Back Hinge/Recliner Mechanism Replace - Front .
  9. Install the seat back frame. Refer to Seat Back Frame Replacement - Front .
  10. Install the seat cushion frame. Refer to Seat Cushion Frame Replacement - Front .
  11. Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  12. Install the front seat in the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals