LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Armrest Replacement - Rear Seat (60/40 Split) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the center armrest to the seat frame.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts to the center armrest.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

    3. Fig 1: Rear Seat Armrest (60/40 Split)
    GM820686Courtesy of GENERAL MOTORS CORP.
  3. Install the cover to the center armrest, if removed.
scientia non olet · About LEMON Manuals