LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Repair Instructions >> Armrest Replacement - Front Seat >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the front seat back in the forward position.
  2. Separate the J-clip at the bottom of the seat using a flat bladed tool.
    3. Fig 1: Separating J-Clip
    GM749102Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2 push pins at the bottom retaining the seat back cover to the card board.
  4. From the back of the front seat, disconnect the heating element wire connector, if equipped.
  5. Role up the seat cover up to the bottom of the arm rest.
  6. Recline the seat.
  7. From the front of the seat move the seat cushion away from the seat frame to gain access to the arm rest clip.
  8. Remove the rubber band from the clip.
  9. Remove the clip from the seat frame.
  10. Remove the arm rest by pulling outwards.
scientia non olet · About LEMON Manuals