LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Seat System) >> Diagnostic Information and Procedures >> Power Seat Inoperative (w/o Memory)

Power Seat Inoperative (w/o Memory)

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Power Seat Inoperative (w/o Memory)

Step Action Yes No
Schematic Reference: Driver Seat Schematics , Passenger Seat Schematics 
Connector End View Reference: Power Seat Systems Connector End Views 
DEFINITION: All of the seat adjuster motors are inoperative, the lumbar and bolster motors may also be inoperative.
1 Did you review the Power Seats System Description and Operation? Go to Step 2  Go to Symptoms - Seats 
2 Verify the condition is present.
Does the system operate normally?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3
  1. Disconnect the seat adjuster switch connector.
  2. Connect a test lamp from the battery voltage supply circuit terminal in the harness connector to a good ground.
Does the test lamp illuminate?
Go to Step 4  Go to Step 5 
4 Connect a test lamp from the battery voltage supply circuit terminal to the ground circuit terminal in the seat adjuster switch harness connector.
Does the test lamp illuminate?
Go to Step 7  Go to Step 6 
5 Repair the battery voltage supply circuit for an open or short to ground. Refer to Wiring Repairs in Wiring Systems.
Is the repair complete?
Go to Step 9  -
6 Repair the ground circuit for an open or high resistance. Refer to Wiring Repairs in Wiring Systems.
Is the repair complete?
Go to Step 9  -
7 Inspect for poor connections at the seat adjuster switch harness connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 8 
8 Replace the seat adjuster switch. Refer to Seat Switch Replacement - Power .
Is the repair complete?
Go to Step 9  -
9 Operate the system to verify the repair.
Did you correct the condition?
System OK Go to Step 3