LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Starter Motor Replacement (6.6L (LB7) Engine) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Starter Motor & Bolts (6.6L (LB7))
    GM660305Courtesy of GENERAL MOTORS CORP.
  1. Install the starter motor to the engine rear cover.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the starter motor bolts.

    Tighten:  Tighten the bolts to 78 N.m (58 lb ft).

  3. Install the solenoid wires.
  4. Install the starter solenoid nut.

    Tighten:  Tighten the nut to 3.4 N.m (30 lb in).

  5. Install the battery positive cable to the solenoid stud.
  6. Install the starter lead nut.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

    7. Fig 2: View Of Positive Battery Cable Nut & Cable From The Starter (6.6L)
    GM674619Courtesy of GENERAL MOTORS CORP.
  7. If equipped with 4WD, install the right fender wheelhouse inner panel (1).
    8. Fig 3: View Of Wheelhouse Panel & Push-In Retainers
    GM401885Courtesy of GENERAL MOTORS CORP.
  8. If equipped with 4WD, install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tire and Wheel.
  9. Lower the vehicle.
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
scientia non olet · About LEMON Manuals