LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Starter Motor Replacement (4.3L Engine) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the starter to the vehicle.
  2. Install the harness to the starter.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    3. Fig 1: View Of Starter Harness (4.3L)
    GM368413Courtesy of GENERAL MOTORS CORP.
  3. Install the starter solenoid nut.

    Tighten:  Tighten the nut to 3.4 N.m (30 lb in).

  4. Install the positive cable (1) to the starter.
  5. Install the starter lead nut (9).

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

    6. Fig 2: View Of Positive Battery Cable Fasteners
    GM785046Courtesy of GENERAL MOTORS CORP.
  6. Install the starter motor bolts.

    Tighten:  Tighten the bolts to 43 N.m (32 lb ft).

    7. Fig 3: View Of Starter Motor & Bolts (4.3L)
    GM7306Courtesy of GENERAL MOTORS CORP.
  7. Lower the vehicle.
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
scientia non olet · About LEMON Manuals