LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Generator Replacement (8.1L Engine) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  2. Disconnect the generator electrical connector (1).
    3. Fig 1: View Of Generator Electrical Connector
    GM750525Courtesy of GENERAL MOTORS CORP.
  3. Remove the generator cable from the generator, perform the following:
    • Slide the boot down revealing the terminal stud.
    • Remove the generator cable nut from the terminal.
    • Remove the generator cable.
    4. Fig 2: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  4. Remove the drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical - 8.1L.
  5. Remove the generator bolts.
  6. Remove the generator.
    7. Fig 3: View Of Generator (8.1L)
    GM751563Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals