LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Generator Bracket Replacement (8.1L Engine) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery cable junction block bracket bolts.
    2. Fig 1: View Of Battery Cable Junction Block Bracket Bolts (8.1L Engine)
    GM759640Courtesy of GENERAL MOTORS CORP.
  2. Remove the fan and clutch. Refer to Fan Clutch Replacement in Engine Cooling.
  3. Remove the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement in Engine Mechanical - 8.1L.
  4. Remove the generator. Refer to Generator Replacement (4.3L Engine)  or Generator Replacement (4.8L, 5.3L, and 6.0L Engines)  or Generator Replacement (6.6L (LB7) Engine)  or Generator Replacement (6.6L (LLY) Engine)  or Generator Replacement (8.1L Engine) .
  5. Remove the generator bracket bolts and nut.
  6. Remove the generator bracket stud.
  7. Remove the generator bracket.
    8. Fig 2: View Of Generator Bracket & Bolts (8.1L)
    GM751458Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals