LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Generator Bracket Replacement (4.8L, 5.3L, and 6.0L Engines) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the generator bracket.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the generator bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 1: View Of Generator Bracket & Bolts (4.8L, 5.3L & 6.0L)
    GM847280Courtesy of GENERAL MOTORS CORP.
  3. Install the power steering pump. Refer to Power Steering Pump Replacement (4.3L) or Power Steering Pump Replacement (4.8L, 5.3L and 6.0L) or Power Steering Pump Replacement (8.1L) or Power Steering Pump Replacement (6.6L Diesel) or Power Steering Pump Replacement (Parallel Hybrid Truck) in Power Steering System.
  4. Install the generator. Refer to Generator Replacement (4.3L Engine)  or Generator Replacement (4.8L, 5.3L, and 6.0L Engines)  or Generator Replacement (6.6L (LB7) Engine)  or Generator Replacement (6.6L (LLY) Engine)  or Generator Replacement (8.1L Engine) .
  5. Install the battery cable junction block bracket bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    6. Fig 2: View Of Battery Cable Junction Block Bracket & Bolts
    GM759636Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals