LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Energy Storage Box (ESB) 120V Receptacle Face Plate Replacement (5.3L Engine w/RPO HP2) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the receptacle face plate (2) to the receptacle box (3).
  2. Push inward until the retaining tabs lock into the openings (1) in the receptacle box.
    3. Fig 1: View Of Receptacle Outlet, Openings, & Face Plate (5.3L Engine w/RPO HP2)
    GM1343162Courtesy of GENERAL MOTORS CORP.
  3. Install the receptacle box (2) into the ESB.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the receptacle outlet screws (1).

    Tighten:  Tighten the screws to 0.5 N.m (4.4 lb in).

    5. Fig 2: View Of Receptacle Box & Outlet Screws (5.3L Engine w/RPO HP2)
    GM1343181Courtesy of GENERAL MOTORS CORP.
  5. Connect the 120-volt AC electrical connector (3).
    6. Fig 3: View Of 42-Volt Positive/Negative Cable Electrical Connector, AC Electrical Connector, Ground Strap & Stud
    GM1237048Courtesy of GENERAL MOTORS CORP.
  6. Install the ESB intermediate cover. Refer to Energy Storage Box (ESB) Trim Cover Replacement (5.3L Engine w/RPO HP2) .
scientia non olet · About LEMON Manuals