LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Battery Replacement - Auxiliary >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Auxiliary Battery & Insulator
    GM662956Courtesy of GENERAL MOTORS CORP.
  1. Install the battery insulator, if necessary.
  2. Install the auxiliary battery.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install battery hold down retainer and bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  4. Connect the auxiliary positive battery cable (1).

    Tighten:  Tighten the bolt to 17 N.m (13 lb ft).

  5. Snap the auxiliary positive battery cable cap closed.
    6. Fig 2: View Of Auxiliary Positive Battery Cable, Relay Nut & Boot
    GM847264Courtesy of GENERAL MOTORS CORP.
  6. Connect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
scientia non olet · About LEMON Manuals