LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Battery Positive Cable Replacement - Battery Relay to Starter - Auxiliary >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  2. Reposition the boot.
  3. Remove the auxiliary positive battery cable nut.
  4. Remove the auxiliary positive battery cable from the auxiliary relay.
  5. Remove the auxiliary positive battery cable clip from the battery tray.
    6. Fig 1: View Of Auxiliary Positive Battery Cable Nut
    GM662684Courtesy of GENERAL MOTORS CORP.
  6. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  7. Remove the auxiliary cable clip bolt from the frame.
    8. Fig 2: View Of Auxiliary Cable Clip Bolt At Frame
    GM662688Courtesy of GENERAL MOTORS CORP.
  8. Remove the starter lead nut.
  9. Remove the auxiliary positive battery cable from the starter stud.
    10. Fig 3: View Of Auxiliary Positive Battery Cable At Starter Stud
    GM662690Courtesy of GENERAL MOTORS CORP.
  10. Remove the auxiliary positive battery cable.
scientia non olet · About LEMON Manuals