LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Battery Positive Cable Replacement - Auxiliary (6.6L (LLY) Engine) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the auxiliary battery negative cable (2). Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  2. Unsnap the positive battery cable cap.
  3. Disconnect the positive battery cable (1).
    4. Fig 1: View Of Auxiliary Battery Positive & Negative Cable (6.6L (LLY))
    GM1369541Courtesy of GENERAL MOTORS CORP.
  4. Remove the auxiliary battery cable clip from the fender wheelhouse inner panel.
  5. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  6. Remove the cable clip bolt (5) at the frame.
  7. Remove the auxiliary battery negative cable bolt (4).
  8. Remove the battery cable retainer nut (6) and the retainer.
  9. Remove the battery positive cable from the retainer.
  10. Remove the positive battery cable nut (7).
  11. Remove the positive battery cable lead (8) from the starter.
    12. Fig 2: View Of Cables, Connector & Retainers - Lower Right Of Engine
    GM1369543Courtesy of GENERAL MOTORS CORP.
  12. Remove the auxiliary battery cable.
scientia non olet · About LEMON Manuals