LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Battery Negative Cable Replacement - Auxiliary (6.0L and 8.1L Engines) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
    2. Fig 1: View Of Auxiliary Battery Negative Cable (6.0L & 8.1L)
    GM662415Courtesy of GENERAL MOTORS CORP.
  2. Remove the auxiliary battery cable clips from the studs at the front of dash.
  3. Remove the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L Engines) or Engine Sight Shield Replacement (6.0L Engine w/RPOs Y91 and Z88) in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
  4. Remove the engine wiring harness/auxiliary negative battery cable bolt.
    5. Fig 2: View Of Engine Wiring Harness/Auxiliary Negative Battery Cable Bolt
    GM662418Courtesy of GENERAL MOTORS CORP.
  5. Remove the auxiliary negative battery cable.
scientia non olet · About LEMON Manuals