LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Battery, Charging System & Starting System) >> Repair Instructions >> Battery Negative Cable Replacement (6.6L (LLY) Engine) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  2. Remove the negative cable clip (1) from the power steering pump bracket.
    3. Fig 1: View Of Power Steering Pump Bracket Negative Cable Clip (6.6L (LLY) Engine)
    GM1369538Courtesy of GENERAL MOTORS CORP.
  3. Remove the negative cable from the positive cable clip.
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Remove the negative battery cable bolt (1).
    6. Fig 2: View Of Negative Battery Cable Bolt (6.6L (LLY) Engine)
    GM1369539Courtesy of GENERAL MOTORS CORP.
  6. Remove the forward lamp wiring harness ground/negative cable bolt (3).
  7. Remove the negative battery cable (1).
    8. Fig 3: View Of Negative Battery Cable, Forward Lamp Wiring Harness & Ground/Negative Cable Bolt (6.6L (LLY) Engine)
    GM1369540Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals