Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the energy storage box (ESB). Refer to Energy Storage Box (ESB) Service Disconnect/Connect (5.3L Engine w/RPO HP2) .
- Disconnect the accessory power receptacle electrical connector (1) at the starter/generator control module (SGCM).
- Remove the accessory power receptacle harness clip (2) from the tray.
- Remove the accessory power receptacle to 42V electrical connector clip.
- Disconnect the accessory power receptacle electrical connector (1) to 42V electrical connector (2).
- Remove the accessory power receptacle harness clips from the engine harness.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the accessory power receptacle harness clips from the frame front side rail.
- Remove the accessory power receptacle harness clips from the frame side rail.
- Remove the accessory power receptacle harness clips from the frame rear side rail.
- Remove the accessory power receptacle harness ground wire bolt (1).
- Reposition the ground wire from the frame.
- Disconnect the accessory power receptacle harness electrical connector from the receptacle.
- Remove the accessory power receptacle harness from the vehicle.
Fig 3: View Of Accessory Power Receptacle Electrical Connector To 42V Electrical Connector (5.3L Engine w/RPO HP2)
Fig 5: View Of Accessory Power Receptacle Harness Clips At Frame Front Side Rail (5.3L Engine w/RPO HP2)
Fig 8: View Of Accessory Power Receptacle Harness Electrical Connector At Receptacle (5.3L Engine w/RPO HP2)