LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Engine Controls Self-Diagnostics - 6.5L) >> System Tests >> Malfunction Indicator Lamp Always On >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check-Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
  2. Turn ON the ignition, with the engine OFF. Does the MIL turn OFF when the ignition is turned ON? If yes, go to step  5 . If no, go to next step.
  3. Turn OFF the ignition. Disconnect the PCM. Turn ON the ignition, with the engine OFF. Observe the MIL. Does the MIL illuminate? If yes, go to next step. If no, go to step  7 .
  4. Remove the Instrument Panel Cluster (IPC). See appropriate ANALOG INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT. Test the MIL control circuit for a short to ground between the PCM and the IPC. Did you find and correct the condition? If yes, go to step  8 . If no, go to step  6 .
  5. Repair the MIL control circuit for a short to voltage. After repairs, go to step  8 .
  6. Replace the IPC. See appropriate ANALOG INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT. After repairs, go to step  8 .
  7. Replace the PCM. See appropriate REMOVAL, OVERHAUL & INSTALLATION article. Reprogram PCM. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. After repairs, go to next step.
  8. Operate the system in order to verify the repair. Did you correct the condition? If yes, system is okay. If no, go to step  2 .
scientia non olet · About LEMON Manuals