LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Engine Controls Self-Diagnostics - 6.5L) >> Diagnostic Tests >> DTC P0219: Engine OVERSPEED Condition >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check-Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
  2. NOTE: The new injection pump must be timed. See INJECTION PUMP TIMING/TDC OFFSET in appropriate ON-VEHICLE ADJUSTMENTS article.
  3. Replace the fuel injection pump. See appropriate REMOVAL, OVERHAUL & INSTALLATION article. After repairs, go to next step.
  4. Using the scan tool, clear the DTCs. Start engine and idle the engine at the normal operating temperature. Select DTC and the Specific DTC function. Enter the DTC number that was set. Operate the vehicle within the Conditions for Setting DTC until the scan tool indicates the diagnostic ran. Does the scan tool indicate the diagnostic passed? If yes, go to next step. If no, go to step  2 .
  5. Observe the stored information, Capture Info with a scan tool. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  . If no, system is okay.