LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 979 (Manual Transmission Clutch System) >> Repair Instructions >> Release Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: DO NOT use cleaners or chemicals to clean the quill and DO NOT grease the quill.
  1. Using a clean dry cloth, clean the exposed area of the actuator cylinder quill.
    Fig 1: Clutch Release Bearing
    GM71485Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW clutch release bearing to the clutch actuator cylinder.
    • Firmly push the clutch release bearing into place.
    • The release bearing will snap over the retainer tab and will be self-retained to the actuator cylinder.
  3. Install the manual transmission. Refer to:
scientia non olet · About LEMON Manuals