LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 978 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Gasoline/Gasoline Vapors Caution in Cautions and Notices.
CAUTION: Refer to Fuel Gage Leak Caution in Cautions and Notices.
  1. Remove the fuel rail pressure fitting cap.
  2. Connect the J 34730-1A  to the fuel pressure valve. Wrap a shop towel around the fitting while connecting the gage in order to avoid spillage.
  3. Install the bleed hose on J 34730-1A  into an approved container.
    4. Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals