LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 978 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine/Chassis >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel feed/return and EVAP pipe assembly.
  2. Connect the fuel feed/return and EVAP pipe clips.
  3. Install the fuel feed/return and EVAP pipe clip nuts.
  4. Fig 1: View Of Fuel Feed/Return & EVAP Pipe Assembly
    GM878119Courtesy of GENERAL MOTORS CORP.
  5. Remove the caps from the fuel tank pipes.
  6. Fig 2: View Of Fuel Feed/Return Pipes At Fuel Tank
    GM878130Courtesy of GENERAL MOTORS CORP.
  7. Connect the fuel feed/return pipes at the fuel tank pipes. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  8. Install the EVAP canister. Refer to Evaporative Emission (EVAP) Canister Replacement .
  9. If equipped with 4WD, install the fuel feed/return and EVAP pipes to the clip on the transfer case.
  10. Install the fuel feed/return pipe and EVAP pipe clip to the transmission.
  11. Fig 3: View Of Fuel Feed/Return Pipe & EVAP Pipe Clip
    GM300385Courtesy of GENERAL MOTORS CORP.
  12. Lower the vehicle.
  13. Install the fuel feed/return pipe bracket to the stud.
  14. Install the fuel feed/return pipe bracket nut.
  15. Remove the caps from the fuel feed/return and EVAP pipes.
  16. Connect the EVAP pipe (1).
  17. Connect the fuel feed/return pipes (4) at the engine pipes (5).
  18. Fig 4: View Of EVAP Pipe, Fuel Feed/Return Pipes & Engine Compartment Pipes
    GM583167Courtesy of GENERAL MOTORS CORP.
  19. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .