LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 978 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. If necessary, attach the EVAP canister vent valve (2) to the bracket.
  2. If necessary, connect the EVAP vent pipe (3) to the EVAP canister vent valve (2).
  3. Install the EVAP canister vent valve and pipe to the vehicle.
  4. Connect the EVAP vent pipe (4) to the EVAP canister.
  5. Install the EVAP pipe to the clips (1).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    6. Fig 1: View Of EVAP Canister, Vent Pipe & Vent Valve
    GM385856Courtesy of GENERAL MOTORS CORP.
  6. Install the EVAP canister vent valve bracket bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  7. Connect the EVAP canister vent valve electrical connector (1).
    8. Fig 2: View Of EVAP Canister Vent Valve Electrical Connector, Chassis Harness Ground Strap, Fuel Tank Ground Strap Bolt & Fuel Tank Ground Strap
    GM815635Courtesy of GENERAL MOTORS CORP.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals