LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 978 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  2. Disconnect the evaporative emission (EVAP) purge pipe.
    3. Fig 1: View Of EVAP Purge Pipe
    GM869711Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the purge solenoid electrical connector (1).
    4. Fig 2: EVAP Canister Purge Solenoid Valve & MAP Sensor
    GM782178Courtesy of GENERAL MOTORS CORP.
  4. Remove the purge solenoid nuts.
    5. Fig 3: View Of Purge Solenoid Nuts
    GM309187Courtesy of GENERAL MOTORS CORP.
  5. Remove the engine wiring harness bracket from the stud.
  6. Remove the purge solenoid from the intake manifold.
    7. Fig 4: View Of Purge Solenoid
    GM309179Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals