LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 977 (Engine Controls - 6.6L (LLY) (Introduction)) >> Repair Instructions >> Turbocharger Vane Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Turbocharger Vane Position Sensor And Electrical Connector
    GM1334926Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement in Engine Mechanical - 6.6L (LLY).
    2. IMPORTANT: Note wire routing prior to removal.
  2. Disconnect the turbocharger vane position sensor electrical connector.
  3. Remove the turbocharger vane position sensor connector from the bracket.
  4. Remove the turbocharger vane position sensor from the turbocharger.
scientia non olet · About LEMON Manuals