LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 977 (Engine Controls - 6.6L (LLY) (Introduction)) >> Repair Instructions >> Turbocharger Vane Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Turbocharger Vane Position Sensor And Electrical Connector
    GM1334926Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the turbocharger vane position sensor to the turbocharger.

    Tighten:  Tighten the sensor to 28 N.m (21 lb ft).

  2. Install the turbocharger vane position sensor connector to the bracket.
  3. Connect the turbocharger vane position sensor electrical connector.
  4. Install the thermal reflective shield/tape, refer to the following procedure.
scientia non olet · About LEMON Manuals