LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 977 (Engine Controls - 6.6L (LLY) (Introduction)) >> Repair Instructions >> Fuel Rail Temperature (FRT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Temperature Sensor Electrical Connector
    GM1335528Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the fuel temperature sensor.

    Tighten:  Tighten the sensor to 22 N.m (16 lb ft).

  2. Connect the fuel temperature sensor electrical connector.
    3. Fig 2: View Of Turbocharger Clamp & Charged Air Cooler Inlet Duct Connector
    GM1334380Courtesy of GENERAL MOTORS CORP.
  3. Remove the tape from the turbocharger openings.
  4. Install the charged air cooler inlet duct connector (4) to the turbocharger.
  5. Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).

    Tighten:  Tighten the clamp to 6 N.m (53 lb in).

  6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement in Engine Mechanical.
  7. Prime the fuel system. Refer to Fuel System Priming .
  8. Start the engine. If the engine stalls, repeat the above step.
  9. Once the engine starts, inspect for fuel leaks.
scientia non olet · About LEMON Manuals