Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Fuel Pressure Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the fuel pressure sensor (1).
Tighten: Tighten the sensor to 70 N.m (52 lb ft).

Fig 2: View Of Fuel Rail Pressure Sensor And Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the fuel rail pressure sensor electrical connector.
Install the EGR cooler tube. Refer to Exhaust Gas Recirculation (EGR) Valve Cooler Tube Replacement .
Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
Prime the fuel system. Refer to Fuel System Priming .
Start the engine. If the engine stalls, repeat the above step.
Once the engine starts, inspect for fuel leaks.