LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 977 (Engine Controls - 6.6L (LLY) (Introduction)) >> Repair Instructions >> Fuel Filler Hose Replacement (Pickup) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Filler Housing To Body Screws & Retainer
    GM853731Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank filler housing to body screws (1) and retainer (2).
    2. Fig 2: Identifying Fuel Filler Components
    GM300318Courtesy of GENERAL MOTORS CORP.
  2. Remove the fuel tank filler pipe housing to fuel tank fill pipe screws.
  3. Remove the fuel tank filler housing.
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    5. Fig 3: Fuel Tank Ground Strap Bolt
    GM1238144Courtesy of GENERAL MOTORS CORP.
  5. Remove the fuel tank ground strap bolt (1).
  6. Remove the chassis harness ground strap (2) and fuel tank ground strap (3).
    7. Fig 4: View Of Rear Axle Vent Hose On The Fuel Fill Pipe (Pickup)
    GM816707Courtesy of GENERAL MOTORS CORP.
  7. Remove the rear axle vent hose from the clip on the fuel fill pipe bracket.
    8. Fig 5: Fuel Fill Pipe Assembly (Pickup)
    GM1378752Courtesy of GENERAL MOTORS CORP.
  8. Loosen the fuel tank vent hose and fill hose clamps (1, 2).
  9. Remove the vent hose from the tank.
  10. Remove the fill hose from the tank and the vehicle.
  11. Cap the opening on the fuel tank in order to prevent possible fuel system contamination.
scientia non olet · About LEMON Manuals