LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 977 (Engine Controls - 6.6L (LLY) (Introduction)) >> Repair Instructions >> Fuel Filler Hose Replacement (Cab/Chassis) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Fill Pipe Clamp & Vent Pipe Clamp
    GM1228174Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the fuel and vent holes in the fuel tank.
  2. Install the fuel fill and vent hoses to the tank.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the fuel fill and vent hose clamps (1, 2) at the tank.

    Tighten:  Tighten the clamp to 2.5 N.m (22 lb in).

    4. Fig 2: View Of Fuel Feed And Pressure Balance Lines
    GM1228187Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel feed and pressure balance rear lines. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
scientia non olet · About LEMON Manuals