LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 976 (Engine Controls - 6.6L (Lb7) (Introduction)) >> Repair Instructions >> Glow Plug Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the glow plug(s).

    Tighten:  Tighten the plug to 18 N.m (13 lb ft).

  2. Install the buss bar and wiring, if equipped.
  3. Install the glow plug electrical nut.

    Tighten:  Tighten the nut to 2 N.m (18 lb in).

    4. Fig 1: Right Side Engine Harness At Glow Plug
    GM788839Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  5. Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement .
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
scientia non olet · About LEMON Manuals