LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 976 (Engine Controls - 6.6L (Lb7) (Introduction)) >> Repair Instructions >> Glow Plug Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the glow plug(s).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the buss bar (2) and wiring, if equipped.

    Tighten:  Tighten the plug to 18 N.m (13 lb ft).

    3. Fig 1: Buss Bar (Federal Emissions)
    GM660512Courtesy of GENERAL MOTORS CORP.
  3. Install the harness to the desired glow plug(s) (1).
  4. Install the glow plug nuts to the desired glow plug(s).

    Tighten:  Tighten the nut to 2 N.m (18 lb in).

    5. Fig 2: Left Side Engine Harness At Glow Plugs
    GM788840Courtesy of GENERAL MOTORS CORP.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  6. Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
scientia non olet · About LEMON Manuals