LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 976 (Engine Controls - 6.6L (Lb7) (Introduction)) >> Repair Instructions >> Fuel Rail Temperature (FRT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the fuel temperature sensor.

    Tighten:  Tighten the sensor to 22 N.m (16 lb ft).

  2. Connect the fuel temperature sensor electrical connector (1).
    3. Fig 1: Fuel Rail Temperature Sensor Electrical Connector
    GM786977Courtesy of GENERAL MOTORS CORP.
    Fig 2: View Of Charged Air Cooler Inlet Duct & Clamps
    GM877281Courtesy of GENERAL MOTORS CORP.
  3. Install the charged air cooler inlet duct to the turbocharger.
  4. Align the mark on the duct (2) with the mark on the turbocharger.
  5. Position the clamp (1) as shown for proper clearance.

    Tighten:  Tighten the clamp to 6 N.m (53 lb in).

  6. Install the upper intake manifold cover.
  7. Install the upper intake manifold cover to the outlet duct.
  8. Tighten the outlet duct clamp at the upper intake manifold cover.

    Tighten:  Tighten the clamp to 6 N.m (53 lb in).

    9. Fig 3: View Of Upper Intake Manifold Cover, Outlet Duct & Clamp
    GM813243Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals