LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 976 (Engine Controls - 6.6L (Lb7) (Introduction)) >> Repair Instructions >> Fuel Filler Hose Replacement (Cab/Chassis) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caps from the fuel and vent holes in the fuel tank.
  2. Install the fuel fill pipe and vent hose to the tank.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the fuel fill vent hose clamps at the tank.

    Tighten:  Tighten the clamp to 2.5 N.m (22 lb in).

    4. Fig 1: Fuel Fill Pipe And Vent Hose (Cab/Chassis - Front)
    GM877738Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel feed and pressure balance rear pipes. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
    5. Fig 2: Fuel Feed And Pressure Balance Rear Pipes
    GM877728Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals