LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 976 (Engine Controls - 6.6L (Lb7) (Introduction)) >> Repair Instructions >> Boost Sensor Replacement (Federal Emissions) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the sensor (2) onto the bracket (1).
  2. Install the bracket (with sensor) over the stud.
    3. Fig 1: Boost Sensor & Bracket
    GM740442Courtesy of GENERAL MOTORS CORP.
  3. Position the coolant tube (1) over the stud.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the boost sensor bracket nut (4).

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  5. Connect the boost sensor electrical connector (2).
    6. Fig 2: Coolant Tube, Boost Sensor Electrical Connector & Bracket Nut
    GM740438Courtesy of GENERAL MOTORS CORP.
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals