LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 975 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering wheel control switch to the steering wheel.
    Fig 1: View Of Steering Wheel Control Switch Electrical Connector
    GM652807Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the steering wheel control switch.
  3. Install the steering wheel control switch into the steering wheel, ensuring the retaining tabs are fully seated.
    4. Fig 2: View Of Shroud & Screws
    GM755486Courtesy of GENERAL MOTORS CORP.
  4. Install the shroud to the steering wheel.
    5. NOTE: Refer toFastener Notice in Cautions and Notices.
  5. Install the shroud retaining screws to the steering wheel.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Install the steering wheel. Refer to Steering Wheel Replacement .
scientia non olet · About LEMON Manuals